![background image](http://html.mh-extra.com/html/makita/tm3000c/tm3000c_instruction-manual_1722907005.webp)
5
21.
Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear hearing protectors, gloves
and workshop apron capable of stopping
small abrasive or workpiece fragments.
The
eye protection must be capable of stopping flying
debris generated by various operations . The dust
mask or respirator must be capable of filtrating
particles generated by your operation. Prolonged
exposure to high intensity noise may cause
hearing loss.
22.
Keep bystanders a safe distance away from
work area. Anyone entering the work area
must wear personal protective equipment.
Fragments of workpiece or of a broken accessory
may fly away and cause injury beyond immediate
area of operation.
23.
Never lay the power tool down until the
accessory has come to a complete stop.
The
spinning accessory may grab the surface and pull
the power tool out of your control.
24.
Do not run the power tool while carrying it at
your side.
Accidental contact with the accessory
could snag your clothing, pulling the accessory
into your body.
25.
Do not operate the power tool near flammable
materials.
Sparks could ignite these materials.
26.
Do not use accessories that require liquid
coolants.
Using water or other liquid coolants
may result in electrocution or shock.
27.
Always be sure that the tool is switched off
and unplugged before carrying out any work
on the tool.
28.
If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
29.
Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
WARNING:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking
function on the tool.
Failure to switch off and
unplug the tool may result in serious personal
injury from accidental start-up.
Switch action
Fig.1
CAUTION:
•
Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, slide the slide switch toward the "I (ON)"
position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.
Adjusting the orbital stroke rate
Fig.2
The orbital stroke rate is adjustable. To change the orbital
stroke rate, turn the dial between 1 and 5. The higher the
number is, the higher the orbital stroke rate is. Preset the
dial to the number suitable for your workpiece.
NOTE:
•
The dial cannot be turned directly from 1 to 5 or
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke rate
is kept constant even under load condition.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
•
Do not install application tool upside down.
Installing application tool upside down may
damage the tool and cause serious personal injury.
•
Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
Fig.3
Fig.4
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the