OPTIONAL ACCESSORIES
Vise for drill press
Accessories
．
Chuck Key
．
Hex Wrench
PARTS & ACCESSORIES
Pulley Case
Rod Lock Knob
Motor
Handle
Column
Clamp Bolt
Base
Chuck
Work Table
Knob
Switch
Depth Pointer
Depth Shaft
4. Trouble Shooting Guide
TROUBLE
Noisy operation
Excessive
drill wobble
Motor won't
start
PROBABLE CAUSE
A) Incorrect belt tension
B) Dry spindle
C) Loose pulley
D) Loose belt
E) Bad bearing
A) Loose chuck
B) Worn spindle shaft or bearing
C) Bad chuck
A) Power supply
B) Motor connection
C) Switch connections
D) Motor windings burned
E) Bad switch
REMEDY
A) Adjust tension
B) Remove spindle/quill assembly-
lubricate
C) Tighten pulley
D) Adjust belt tension
E) Replace bearing
A) Tighten by pressing chuck down
against table
B) Replace spindle shaft or bearing
C) Replace chuck
A) Check power cord
B) Check motor connections
C) Check switch connections
D) Replace motor
E) Replace switch
1. Installing Drills
Insert drill into chuck jaws about 1" (25.4mm)
long. When using a small drill does not insert it
so far that the jaws touch the arbor of the drill.
Make sure that the drill is centered in the chuck
before tightening the chuck with the key. Fig.
13.
2. Positioning Workpiece
Always place a piece of wood (or plywood...)
on the table. This will prevent "splintering" or
making a heavy hurs on the underside of the
workpiece as the drill breaks through. The
wood must contact the left side of the column.
Fig. 14
3. Using Vise
For small workpiece that cannot be clamped to
the table, use a drill press vise not included.
The vise must be clamped or bolted to the
table.
OPERATION & TROUBLE SHOOTING GUIDE
Fig 13
Fig 14
3
8
