W
iring diagram
P 6 / 6
Fig. 15
Fig. 17
[2] Wiring of the Lead Wires of Pickup Coil
[3] Wiring in Handle
Lead wire of
pickup coil
(white)
Lead wire of
pickup coil
(black)
Rib
Lead wire holder
1) First, route the white lead wire of pickup coil under the rib.
And then hold both of the white and the black lead wires
with the lead wire holder. (Fig. 15)
2) When installing Handle (L) onto Motor housing, route the
two lead wires as illustrated in Fig. 16.
Boss on Handle (L)
Handle (L)
Rib
a) Lead wire from Controller (blue or white)
c) Lead wire from Controller (red)
d) Lead wire from Choke coil (red)*
Note: The position of b and that of d are replaceable.
b) Field lead wire (white)
Switch
Noise suppressor*
Before setting Switch in place, hold the three (or four) lead wires with the lead wire holders under switch as
illustrated below. When using Choke coil, place the lead wire d under other lead wire as illustrated below.
Lead wire holders
Fig. 16
Route the lead wires
that connect Controller
with Speed adjust dial
between these ribs, and
put them under the dial.
Rib Boss
Note: Some countries do not use the electrical parts with an asterisk.
Pickup coil
Motor housing
Pickup coil
Lead wire
holder A
Lead wire
holder B
Lead wire holder C
Speed adjust dial
Controller
Route lead wires between rib and boss
and between rib and wall of handle (L).
With Lead wire holder C, hold more
than one lead wire that is connected
with this insulated terminal.
Insulated connector*
Insulated connector
(Use for connecting the
lead wire from Choke
coil with the lead wire
from Noise suppressor.)
With Lead wire holder A, hold the lead wires that connect
Controller with Connector on Switch.
With Lead wire holder B, hold the other lead wires.
At this time, put the lead wire from Controller (blue or white)
and the lead wire from Choke coil (orange)* under the other
lead wires.
