Makita RT0700C, Инструкция по эксплуатации

Страница: 7 / 20

7
•
When using the trimmer shoe, the straight guide or
the trimmer guide, be sure to keep it on the right
side in the feed direction. This will help to keep it
flush with the side of the workpiece.
1
2
3
4
001985
CAUTION:
•
Since excessive cutting may cause overload of the
motor or difficulty in controlling the tool, the depth
of cut should not be more than 3 mm at a pass
when cutting grooves. When you wish to cut
grooves more than 3 mm deep, make several
passes with progressively deeper bit settings.
Templet guide (optional accessory)
011838
The templet guide provides a sleeve through which the bit
passes, allowing use of the trimmer with templet patterns.
Loosen the screws and remove the base protector.
Place the templet guide on the base and replace the
base protector. Then secure the base protector by
tightening the screws.
1
2
3
2
011839
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
6
10mm (3/8")
7
011982
NOTE:
•
The workpiece will be cut a slightly different size
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
Straight guide (optional accessory)
011840
The straight guide is effectively used for straight cuts
when chamfering or grooving.
1
2
3
4
001990
Attach the guide plate to the straight guide with the bolt
and the wing nut.
1
2
3
4
011841
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
1. Bolt
2. Guide plate
3. Straight guide
4. Wing nut
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide
10
7. Base protector
1. Base protector
2. Screws
3. Screwdriver
1. Feed direction
2. Bit revolving
direction
3. Workpiece
4. Straight guide