9
1
2
55 mm
55 mm
3
004931
When using a large diameter bit, attach pieces of wood
to the straight guide which have a thickness of more
than 15 mm to prevent the bit from striking the straight
guide.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction
of the arrow.
009861
Fine Adjusting Straight Guide (accessory)
009874
When Router is Mounted
Insert the two rods (Rod 10) into the outer mounting
slots of the guide holder, and secure them by tightening
the two clamping screws (M15 x 14mm). Check to make
sure that the thumb nut (M6 x 50mm) is tightened down,
and then slide the router's base mounting unit onto the
two rods (Rod 10), and tighten the base's clamping
screws.
Fine Adjusting Function for Positioning Blade
in Relation to Straight Guide
1
009873
1.
Loosen thumb nut (M6 x 50mm).
2.
Thumb nut (M10 x 52mm) can be turned to adjust
position (one turn adjusts the position by 1mm).
3. After completing position adjustment, tighten
thumb nut (M6 x 50mm) until secure.
Scale ring can be rotated separately, so scale unit can
be aligned to zero (0).
Guide Shoe Width Alteration
Loosen the screws marked by the circles to alter the
width of the guide shoe in the left and right directions.
After altering width, tighten the screws until they are
secure. Guide shoe width (d) alteration range is 280mm
to 350mm.
1
2
009872
1
d
009871
1. When set to
minimum
opening width
1. Screws
2. Movable
1. Adjusting screw
1. More than 15
mm
2. Straight guide
3. Wood
