Makita M372, Инструкция по эксплуатации

Страница: 6 / 12

6
1
2
3
4
001990
Remove the chip deflector.
1
2
3
4
004559
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction
of the arrow.
A
005437
Circular work
1
2
3
4
5
001993
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows:
Min.: 70 mm
Max.: 221 mm
For cutting circles between 70 mm and 121 mm in
radius.
For cutting circles between 121 mm and 221 mm in
radius.
1
2
3
4
5
001994
NOTE:
•
Circles between 172 mm and 186 mm in radius
cannot be cut using this guide.
Align the center hole in the straight guide with the center
of the circle to be cut. Drive a nail less than 6 mm in
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
1
2
3
005438
1. Nail
2. Center hole
3. Straight guide
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
1. Clamp screw
(A)
2. Straight guide
3. Wing nut
4. Base
1. Bolt
2. Guide plate
3. Straight guide
4. Wing bolt