Makita M363, Инструкция по эксплуатации

Страница: 4 / 16

4
Place the tool on a flat surface. Loosen the lock lever
and lower the tool body until the bit just touches the flat
surface. Press the lock lever down to lock the tool body.
While pressing the fast-feed button, move the stopper
pole up or down until the desired depth of cut is obtained.
Minute depth adjustments can be obtained by turning
the stopper pole (1.5 mm per turn).
CAUTION:
•
The depth of cut should not be more than 20 mm at
a pass when cutting grooves. For extra-deep
grooving operations, make two or three passes
with progressively deeper bit settings.
Nylon nut
For tool without the knob
The upper limit of the tool body can be adjusted by
turning the nylon nut. Do not lower the nylon nut too low.
The bit will protrude dangerously.
For tool with the knob
1
005111
By turning the knob, the upper limit of the tool body can
be adjusted. When the tip of the bit is retracted more
than required in relation to the base plate surface, turn
the knob to lower the upper limit. Do not lower the knob
too low. The bit will protrude dangerously.
Stopper block
1
2
3
4
5
004926
As the rotary stopper has three adjusting hex bolts, you
can easily obtain three different depths of cut without
readjusting the stopper pole. To adjust the hex bolts,
loosen the hex nuts on them and turn the hex bolts. After
obtaining the desired position, tighten the hex nuts to
secure the hex bolts.
Switch action
1
004927
CAUTION:
•
Before plugging in the tool, always check to see
that the tool is switched off.
•
Make sure that the shaft lock is released before the
switch is turned on.
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
1
2
3
004928
CAUTION:
•
Install the bit securely. Always use only the wrench
provided with the tool. A loose or overtightened bit
can be dangerous.
•
Do not tighten the collet nut without inserting a bit
or install small shank bits without using a collet
sleeve. Either can lead to breakage of the collet
cone.
Insert the bit all the way into the collet cone. Press the
shaft lock to keep the shaft stationary and use the
wrench to tighten the collet nut securely. When using
router bits with smaller shank diameter, first insert the
appropriate collet sleeve into the collet cone, then install
the bit as described above.
To remove the bit, follow the installation procedure in
reverse.
1. Shaft lock
2. Wrench
3. Bit
1. Switch lever
1. Stopper pole
2. Chip deflector
3. Stopper
4. Adjusting hex
bolt
5. Hex nut
1. Knob