8
013567
Insert the cartridge into the holder as illustrated.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
Installing the cartridge into the long holder
(600ml(36.6cu.in))
1
2
013572
Remove the holder cap from the holder.
Pull the rod handle backwards slowly until it stops.
1
013571
Insert the cartridge into the holder.
Attach the holder cap. Make sure it is tightened firmly.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, remove the holder cap, then
take out the cartridge.
NOTICE:
•
Always check the cartridge for puncture or
damage before installing. Do not use damaged
cartridge, otherwise the tool may be damaged.
•
When using a partially used cartridge, remove any
adhered material on the cartridge.
Installing film type pack
NOTICE:
•
Make sure the piston B is attached to the rod. Do
not use other type of piston for film type pack.
•
Film type pack can be installed in the long holder
(600ml(36.6cu.in)) only.
Remove the holder cap, the nozzle and the rubber ring
from the holder.
Pull the rod handle backwards slowly until it stops.
013555
Cut off the tip of the film type pack.
Insert the film type pack into the holder.
1
3
013569
Attach the rubber ring, the nozzle and the holder cap.
Make sure holder cap is tightened firmly.
Push the rod gently until the piston touches the bottom
of the film type pack.
NOTE:
•
Always check the film type pack for puncture or
damage before installing. Do not use damaged
pack, otherwise the tool may be damaged.
Direct filling
NOTICE:
•
Make sure the piston C is attached to the rod. Do
not use other type of piston for direct filling.
•
Direct filling can only be performed with the long
holder (600ml(36.6cu.in)).
Remove the holder cap, the nozzle and the rubber ring
from the holder.
Make sure the rod handle is placed at the most front
position.
Dip the mouth of the holder into the caulking material.
Pull the rod handle slowly until required amount of
caulking material is filled in the holder.
1. Rubber ring
2. Nozzle
3. Holder cap
1. Holder cap
1. Holder cap
2. Rod handle
