P
16
/ 2
2
R
epair
Fig. 47
[3] DISASSEMBLY/ASSEMBLY
[3]-7. Swash bearing section
Stop ring E-6
Flat washer 7
Bearing retainer
Spur gear 10 Clutch cam A
Swash bearing 10
Bearing box
Cam shaft
Flat washer 8
Ball bearing 608ZZ
Helical
gear 26
DISASSEMBLING
Fig. 44
Fig. 43
Fig. 45
Fig. 46
(1) Disassemble Motor housing section, Gear housing section and Inner housing section. As for HR2610F and HR2611F,
remove two M4x12 Hex socket head bolts. And then separate Counter weight section from Inner housing complete.
(
Fig. 43
)
(2) Remove two M4x16 Hex socket head bolts with hex wrench 3 and 1R228. (
Fig. 44)
Then pull Swash bearing section out of Inner housing complete. (
Fig. 45
)
(3) Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section. (
Fig. 46
)
(4) Remove Stop ring E-6 from Can shaft, then separate Flat washer 7, Spur gear 10 and Clutch cam A from Can shaft.
Receive Swash bearing 10 on 1R034 and press out Cam shaft with Arbor press.
The swash bearing section can be removed as drawn in
Fig. 47
.
Push Piston cylinder into Inner housing
complete to tilt Swash bearing 10.
Pull Swash bearing section horizontally
with Swash bearing 10 kept tilted, and
remove the pole of Swash bearing 10
toward the tilted direction.
Swash bearing section
(
Note
: Ball bearing 606ZZ is left in Gear housing complete.)
Swash bearing 10
M4x16 Hex socket
head bolt (2 pcs.)
M4x12 Hex socket
head bolt (2 pcs.)
Note
: These are thread
locking screws.
Do not reuse them without applying
ThreeBond 1321B/ 1342 or Loctite 242..
Inner housing complete
Insert shaft portion of Spur gear 10
to the hole of Ball bearing 606ZZ,
and tilt it either backward or
forward.
Tap Gear housing complete with plastic hammer.
Ball bearing 606ZZ is removed together with
Swash bearing section.
Piston cylinder
Ball bearing 606ZZ
in Gear housing
complete
Ball bearing 606ZZ
Plate
Pin 6
Weight holder guide
For HR2610F and HR2611F
only
Counter weight
