Makita HF27231, Инструкция по эксплуатации

Страница: 4 / 68

4
ENGLISH (Original instructions)
Explanation of general view
1-1. Clamping screw
1-2. Blade lower limit stopper
2-1. Quick stop button
3-1. Quick stop button
4-1. Clamping screws
4-2. Tool base
5-1. Positive stopper
6-1. Lever
7-1. Bevel angle shifting lever
8-1. Base
8-2. Cutting line
9-1. Lock-off button 9-2. Switch trigger
10-1. Speed adjusting dial
11-1. Hex wrench
12-1. Lock-off button
12-2. Locking lever
13-1. Locking lever
14-1. Hex wrench
14-2. Shaft lock
15-1. Hex bolt
15-2. Outer flange
15-3. Saw blade
15-4. Inner flange 16-1. Vacuum cleaner
16-2. Dust port
18-1. Adjusting screws
19-1. Slide lever
20-1. Rip fence (Guide rule)
21-1. Rear edge of tool base
21-2. Fixed stop
23-1. Adjusting screw for 90
ﾟ
24-1. Adjusting screw for 45
ﾟ
25-1. Limit mark
26-1. Screwdriver
26-2. Brush holder cap
SPECIFICATIONS
Model SP6000
Blade diameter 165 mm
at 90° 56 mm
at 45° 40 mm
Max. cutting depth
at 48° 38 mm
No load speed (min
-1
) 2,200 - 6,400
Overall length 341 mm
Net weight 4.4 kg
Safety class /II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE067-1
Intended use
The tool is specially intended for performing plunge cuts.
In addition, lengthways and crossways straight cuts and
mitre cuts with angles in wood can also be performed
while in firm contact with the workpiece.
If the tool is equipped with the special saw blade for
aluminium, the tool can be used for sawing aluminium.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 81 dB (A)
Sound power level (L
WA
) : 92 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : cutting wood
Vibration emission (a
h,W
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Work mode : cutting metal
Vibration emission (a
h,M
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.