C
ircuit diagram
W
iring diagram
P 5 / 6
Color index of lead wires' sheath
Black
White
Red
Orange
Blue
Power supply cord
Controller
Switch
Field
Pick up coil
Noise
suppressor
Insulated
terminal
Insulated
terminal
Insulated
terminal
[1] Wiring on Motor Housing
Choke coil
Insulated
terminal
Blue or white
The parts illustrated in this
gray square are not used
for some countries.
1) Draw the lead wires of (a), (b), (c), (d), (e) and (f)
through the openings (areas colored gray), and hold
them with lead wire holders. (Fig. 14)
2) And then route the lead wires as illustrated below
in Fig. 14.
Note: Illustrated in Fig. 14 is Motor housing
viewed from the side of A.
Fig. 13
Fig. 14
Pickup coil
(d) Connecting lead wire (black)
of brush holder
(e) Connecting lead wire (black)
of brush holder
(b) Field lead wire (black)
Put (f) Field lead wire (black) on the
lead wire from Choke coil (orange)*
when holding them with lead wire
holder.
Put insulated terminal
in this compartment
on Motor housing.
Put insulated terminal
in this compartment
on Motor housing.
(c) Field lead wire (black)
(a) Field lead wire (white)
Lead wire from
Choke coil (orange)*
Hold the lead wire from
Choke coil (orange)*
with the lead wire holders
located outside of the
lead holders for (c) Field
lead wire (black).
Lead wire from Choke coil (orange)*
Choke coil*
Put choke coil* into
the opening.
Lead wire
holders
Put (a) Field lead wire (white) under
(b) Field lead wire (black) when
holding them with lead wire holders.
(f) Field lead wire (black)
[A]
Motor housing
*Some countries do not use Choke coil.
