8
For tool with clamp lever type wheel guard
1
2
3
4
009430
Pull the lever in the direction of the arrow after loosening
the screw. Mount the wheel guard with the protrusions on
the wheel guard band aligned with the notches on the
bearing box. Then rotate the wheel guard around 180
゚
.
1
2
009431
Tighten the wheel guard with fastening the screw after
pulling lever in the direction of the arrow. The setting
angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
wheel or multi-disc (optional accessory)
WARNING:
•
When using a depressed center wheel or multi-disc,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
1
2
3
012802
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1
2
012727
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing flex wheel (optional
accessory)
WARNING:
•
Always use supplied guard when flex wheel is on
tool. Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
2
3
4
012740
Follow instructions for depressed center wheel but also
use plastic pad over wheel. See order of assembly on
accessories page in this manual.
Installing or removing abrasive disc (optional
accessory)
NOTE:
•
Use sander accessories specified in this manual.
These must be purchased separately.
1
2
3
012742
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the sanding lock nut onto the
spindle. To tighten the sanding lock nut, press the shaft
1. Sanding lock nut
2. Abrasive disc
3. Rubber pad
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange
1. Lock nut wrench
2. Shaft lock
1. Lock nut
2. Depressed
center wheel
3. Inner flange
1. Screw
2. Lever
1. Wheel guard
2. Bearing box
3. Screw
4. Lever