Makita GA012G, Инструкция по эксплуатации, Страница: 14 / 20

14 ENGLISH
NOTE: Ezynut can be loosened by hand as long
as the arrow points the notch. Otherwise a lock nut
wrench is required to loosen it. Insert one pin of the
wrench into a hole and turn Ezynut counterclockwise.
Installing abrasive cut-off / diamond
wheel
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
(In some European countries, when using a diamond
wheel, the ordinary guard can be used. Follow the
regulations in your country.)
WARNING:
NEVER use cut-off wheel for side
grinding.
1
3
2
4
► 1. Lock nut 2. Abrasive cut-off wheel / diamond
wheel 3. Inner flange 4. Wheel guard for abrasive
cut-off wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
For 100 mm (4″) model
When installing the abrasive cut-off wheel:
16 mm (5/8″) 16 mm (5/8″)
1 1
4
4
2 3
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
mm (5/32")) 3. Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange
When installing the diamond wheel:
1 1
4
4
2 3
►
1.
Lock nut
2.
Diamond wheel (Thinner than 4 mm
(5/32″)) 3. Diamond wheel (4 mm (5/32″) or thicker)
4. Inner flange
For 115 mm (4 - 1/2″) / 125 mm (5″)
model
When installing the abrasive cut-off wheel:
1 1
4 4
2 3
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
mm (5/32"))
3.
Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange