Makita EM4341, Инструкция по эксплуатации

Страница: 10 / 28

9
CAUTION: Before doing any work on the brush cutter, always switch off the
motor and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
– After checking the parts, fasten the drive shaft to the engine with four bolts
M6 x 22(1).
– Mount the stand by two screws M5 x 14.
MOUNTING OF HANDLE For BH3600
For EM4340
– Place the handle with the throttle lever on the handle holder on the right side
(to be held by the right hand) and the other on the left side.
– Fit the handle edge to the handle holder groove, and provisionally fix the
upper side (3) of the handl e holder by four bolts M5 x 25 (4).
– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)
uniformly on the right and left sides.
– Fix the control cable to the shaft by two clips (5).
ASSEMBLY OF ENGINE AND SHAFT FOR EM4340, EM4341
MOUNTING OF HANDLE FOR EM4340, EM4341
㩷
㩷
(1)
(2)
㩷
Clips (5)
㩷
(4)
(3)