13
PUTTING INTO OPERATION
CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
Sequence
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
Place the Power Cut on a stable surface and carry out the fol-
lowing assembly steps:
10
2
8
1
11
Mounting the cutting disc
Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 6.
Unscrew screw (
9
) and remove the spring washer (
8
).
Place the cutting disc (
5
) on the arbour (
7
).
NOTE:
The arbor hole of the cutting disc must be an exact
Þ
t
with the arbor or shaft.
For cutoff discs with 25.4 mm (1”) arbor holes, use the cor-
rect size disc holder (supplied only with cutoff discs with 25.4
mm (1”) arbor holes).
Non-compliance can cause serious
injury!
Make sure the cutting disc is installed so it turns in the right
direction, if a direction is marked on the disc.
Place the spring washer (
8
) on the arbour and insert the screw
(
9
) and tighten by hand.
Slowly turn the cutoff disc until a hole (
11
) in the V-belt pulley is
visible in the counter-holding opening (
10
) of the cutting arm.
Insert the Allen key (
2
) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (
1
).
NOTE:
Tighten the screw
Þ
rmly (30 ± 2 Nm), as otherwise
the cutting wheel may slip during cutting.
Remove the Allen key and combination tool.
