17
12
11
4
3
2
15
8
10
Pull the chain (
8
) around the sprocket nose (
10
) of the guide
bar in the direction of the arrow.
Tightening the saw chain
Simultaneously push in hard on the sprocket guard quick
tensioner (
2
) and turn it clockwise to screw the sprocket
guard on, but do not yet tighten it.
Raise the tip of the guide bar slightly and turn the chain ten‑
sioner (
3) clockwise until the saw chain is flush against the
bottom of the guide bar (see circle).
Push the sprocket guard quick tensioner (2
) in again and
tighten by turning clockwise.
Release the sprocket guard chain tensioner until it turns
freely, then fold it in between protective ribs (
15
) as shown
in the illustration.
Align hole on sprocket guard (
4
) with the pin (
11).
Turn the chain tensioner (
3, see “Tightening the saw chain”)
to bring the chain tensioner pin (
12
) into alignment with the
hole in the guide bar.
Push the sprocket guard (
4
) onto the pin (
11).
Содержание EA3203S
Страница 39: ...39 ...
Страница 40: ...Makita Corporation Anjo Aichi Japan 884987D228 www makita com ALA ...
