Makita DTDA040 Series, Инструкция по эксплуатации

Страница: 11 / 16

11 ENGLISH
LED indicator / beeper
1
► 1. LED indicator
LED indicator / beeper on the tool shows the following functions.
Alarm No. Function Status of the tool Status of the LED indicator/beeper Action to be taken
LED indicator Beeper
E0 Battery installation
error
If the battery car-
tridge is installed
with the switch
trigger pulled, the
tool stops to avoid
unintentional start.
Blinks in red and
green alternatively.
A series of long
beeps
Install the battery
cartridge with
the switch trigger
released.
E1 Auto-stop The battery power
became low and it is
time to replace the
battery cartridge.
Blinks in red and
green alternatively.
A series of long
beeps
Replace the battery
with fully charged
one.
E2 Anti-reset of
controller
The battery voltage
dropped abnormally
for some reason, and
the tool stopped.
Blinks in red and
green alternatively.
A series of long
beeps
Replace the battery
with fully charged
one.
E3 Auto-stop with low
remaining battery
capacity
The battery power is
almost used up and
the tool stopped.
Lights up in red. A long beep Replace the battery
with fully charged
one.
E4 Overload protection The tool was over-
loaded and stopped.
Blinks in red and
green alternatively.
A series of long
beeps
Remove the cause
of overload, and
then restart the tool.
Ask your local
Makita Service
Center for repair.
E5 Overheat protection Tool's controller
heated up abnor-
mally and the tool
stopped.
Blinks in red quickly. A series of long
beeps
Remove the battery
cartridge immedi-
ately and cool the
tool down.
E6 Motor lock The motor has been
locked. At this time,
the tool does not
work.
Blinks in red and
green alternatively.
A series of long
beeps
Release the switch
trigger and pull it
again.
E7 Motor failure The tool detected a
motor failure. At this
time, tool does not
work.
Blinks in red and
green alternatively.
A series of long
beeps
Ask your local
Makita Service
Center for repair.
E8 Switch failure The tool detected a
switch failure.
Blinks in red and
green alternatively.
A series of long
beeps
Ask your local
Makita Service
Center for repair.
E9 Alarm for a long
period of use
The tool has been
turned on for a long
time (Approx. 3
minutes).
Blinks in red and
green alternatively.
A long beep Release the switch
trigger and pull it
again.
- Auto-stop with fas-
tening completion
The preset fasten-
ing torque has been
achieved and the
tool has stopped.
Lights up in green
for approximately
one second.
– –