![background image](http://html.mh-extra.com/html/makita/dst110/dst110_instruction-manual_230441006.webp)
6
ASSEMBLY
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before carrying out any work on the pin
nailer.
Staples
•
Handle the staples and their box carefully. If the
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
•
Avoid storing the staples in a very humid or hot
place or place exposed to direct sunlight.
CAUTION:
•
Do not use staples other than designated in this
manual or staples that appear to be damaged, bent,
rusty or corroded.
•
Do not insert staples of which size is different each
other at the same time inside the magazine ,
causing poor staple feed or jamming.
Loading staples
Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
Fig.6
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
Fig.7
To secure the sub magazine in place, hook the locking
lever on the rear of the sub-magazine.
CAUTION:
•
With the magazine loaded, if the tool is held
downward and the sub-magazine is opened, the
staples can fall out and present a danger to anyone
or anything below. Keep this in mind especially
when working in high locations.
Unloading staples
CAUTION:
•
When removing staples, make sure that your
fingers are not placed on the trigger or the lever
and the battery cartridge is removed from the
stapler. Misfiring may cause personal injuries and
property damage.
Remove the battery cartridge.
Press the locking lever and slide the magazine back.
Take out staples from the magazine slit.
Hook
CAUTION:
•
Always make sure that your fingers are not placed
on the trigger or the lever and the battery cartridge
is removed before using the hook.
Fig.8
CAUTION:
•
Do not hang the hook from the waist belt. Dropping
the stapler, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Fig.9
OPERATION
Driving staples
WARNING:
•
Before pulling the trigger, always make sure that
the opening from which staples are fired contacts
material to be fastened. Just pulling the trigger fires
staples. Misfiring may cause personal injuries.
Fig.10
Place flat the opening of the tool from which staples are
fired on the material to be fastened and hold the tool
firmly against the material. Then pull the lever and then
pull the trigger fully to drive the staples. The grip is
shaped so that the tool head can be held down securely
with index finger and thumb. After driving a staple, be
sure to release the trigger fully.
When the head of driven staple remains above the
surface of material to be fastened, drive the staple while
holding the stapler head firmly.
Fig.11
NOTE:
•
When the trigger is pulled after a quick trigger
action, the stapler may do nothing but operates
momentarily and may not fire staples. This is not a
trouble. At this time, release the trigger once, pull it
again and the staples can be fired.
•
Using the stapler continuously with the head of
driven staples remaining above the surface of
material to be fastened may cause damage to the
driver of the stapler and stapler jamming etc..
Checking remaining staples
Fig.12
Remaining staples can be checked through the
finestella.
New staples can be loaded when the pusher is seen in
the center of the finestella.