14 ENGLISH
NOTE:
Before cutting on the actual workpiece, it is
recommended to make a sample cut. The proper feed
speed depends on the trimmer bit size, the kind of
workpiece, and depth of cut. Moving the tool forward
too fast may cause a poor quality of cut, or damage
to the bit or motor. Moving the tool forward too slowly
may burn and mar the cutting surface.
When using the trimmer shoe, the straight guide, or the
trimmer guide, be sure to keep it on the right side in the
feed direction. This will help to keep it flush with the side
of the workpiece.
1
3
2
►
1.
Trimmer bit
2.
Workpiece
3.
Straight guide
NOTICE:
Since excessive cutting may cause
overload of the motor or difficulty in controlling
the tool, the depth of cut should not be more than
3 mm at a pass when cutting grooves.
When you
wish to cut grooves more than 3 mm deep, make
several passes with progressively deeper bit settings.
Using the straight guide
Optional accessory
1.
Assemble the straight guide with the bolt and the
wing nut.
2
1
►
1.
Bolt
2.
Wing nut
2.
Attach the straight guide to the trimmer base with
the clamp screw.
1
►
1.
Clamp screw
3.
Loosen the wing nut on the straight guide and
adjust the distance between the bit and the straight
guide. At the desired distance, tighten the wing nut.
1
►
1.
Wing nut
4.
Move the tool with the straight guide flush with the
side of the workpiece.