![background image](http://html1.mh-extra.com/html/makita/dpj180rtj/dpj180rtj_instruction-manual_4281647009.webp)
9
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the front
of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing the blade
Fig.12
CAUTION:
•
When installing the plate joiner blade, mount the
inner flange with the side marked "22" facing
toward you.
To remove the blade, loosen the clamp screw and open
the blade cover. Push the shaft lock and loosen the lock
nut using the lock nut wrench. To install the blade, first
mount the inner flange.
Then mount the blade and the lock nut. Securely tighten
the lock nut using the lock nut wrench. Close the blade
cover and tighten the clamp screw to secure the blade
cover.
CAUTION:
•
Use only Makita lock nut wrench provided to
remove or install the blade.
•
Always check the depth of groove after replacing
the blade. Reajust it if necessary.
Dust bag
Fig.13
To attach the dust bag, fit it onto the dust nozzle. If the
dust bag becomes an obstacle to your work, turn the
dust nozzle to change the dust bag position.
When the dust bag is about half full, switch off and
remove the battery cartridge. Remove the dust bag from
the tool and pull the bag's fastener out. Empty the dust
bag by tapping it lightly to remove as much of the dust
as possible.
NOTE:
•
If you connect a Makita vacuum cleaner to your
plate joiner, more efficient and cleaner operations
can be performed.
OPERATION
How to make joints
WARNING:
•
Always clamp the workpiece to the workbench
before each operation.
Fig.14
Fig.15
Corner Joint (Fig. A)
Fig.16
Fig.17
Fig.18
T-Butt Joint (Fig. B)
Fig.19
Fig.20
Fig.21
Miter Joint (Fig. C)
Fig.22
Fig.23
Frame Joint (Fig. D)
Fig.24
Fig.25
Edge-To-Edge Joint (Fig. E)
Fig.26
Fig.27
To make joints, proceed as follows:
1. Fit the two workpieces together as they will
appear in the finished joint position.
2.
Mark the center of the intended biscuit grooves
on the workpiece using a pencil.
NOTE:
•
The center of grooves should be at least 50
mm from the outer edge of the workpieces.
•
Allow 100 mm - 150 mm between grooves in
multiple biscuit application.
Содержание DPJ180RTJ
Страница 4: ...4 1 2 31 012515 ...
Страница 59: ...59 ...
Страница 60: ...60 Makita Corporation Anjo Aichi Japan www makita com 885297 973 ...