6
•
For the switch lever, pull the lock-off lever and
then pull the switch lever to start the tool.
•
For the switch trigger, depress the lock-off button
and then pull the switch trigger to start to the tool.
The lock-off button can be pressed from either
right or left.
The tool speed is increased by increasing pressure on
the switch lever/trigger. Release the switch lever/trigger
to stop.
NOTICE:
Do not pull the switch lever/trigger hard without pulling
the lock-off lever/button. This can cause switch
breakage.
Lighting up the front lamp
1
014053
CAUTION:
•
Do not look in the light or see the source of light
directly.
Pull the switch lever/trigger to light up the lamp. The
lamp keeps on lighting while the switch lever/trigger is
being pulled.
The lamp automatically turns off 10-15 seconds after
releasing the switch lever/trigger.
Adjusting the shoe
1
3
2
014201
When the blade loses its cutting efficiency in one place
along its cutting edge, reposition the shoe to utilize a
sharp, unused portion of its cutting edge. This will help
to lengthen the life of the blade.
To reposition the shoe, loosen the bolt with hex wrench.
Slide the shoe to the desired position and then tighten
the bolt firmly.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the saw blade
CAUTION:
•
Always clean out all chips or foreign matter
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
For Model DJR183
1
2
014058
Insert the recipro saw blade into the blade clamp as far
as it will go. The blade clamp sleeve rotates and fixes
the saw blade. Make sure that the saw blade cannot be
extracted even though you try to pull it out.
CAUTION:
•
If you do not insert the saw blade deep enough,
the saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
NOTE:
•
You can not use the jig saw blade with DJR183
1
2
014059
To remove the saw blade, rotate the blade clamp sleeve
in the direction of the arrow fully. The saw blade is
removed and the blade clamp sleeve is fixed at the
released position.
1. Saw blade
2. Blade clamp
sleeve
1. Recipro saw
blade
2. Blade clamp
sleeve
1. Hex wrench
2. Hex bolt
3. Loosen
1. Lamp
