Makita DFL201R, Инструкция по эксплуатации

Страница: 9 / 64

9 ENGLISH
For LED#B
► Fig.7: 1. LED#B1 2. LED#B2
LED indicator / Beeper on the tool shows the following functions.
Green
Red
lights up when the tool is connected to a receiver.
blinks
when the tool is on the step of being connected to a
receiver. (Note 1)
is turned off
one of the status below
when the battery cartridge is removed from the tool.
when the tool is left idle for more than 15 minutes
with a installed battery cartridge.
when the tool is not within the transmission
distance. (Note 2)
lights up
when the tool's stored number of data reaches its
storable number of data.
when the tool's stored number of data is equal to or
smaller than its storable number of data.
when the tool has no stored data to transmit to a
receiver.
Description Viewed color View and status
1
2
3
blinks
is turned off
1
2
3
3-1
3-2
3-3
LED#B
LED#B
Note 1: Refer to a instruction manual of receiver (accessory) RCV02 when connecting it.
Note 2: Communication distance: 10 m or less (variable up to 10 m depending on the operation environment)
CAUTION:
• Make sure that LED#B2 does not light up before removing a battery cartridge from the tool. If a battery car-
tridge is removed while LED#B2 lights up or blinks, tools stored data will be deleted.
Adjusting the fastening torque
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures ring.
(Loosen the two screws that secure ring only for
DFL201R)
► Fig.8: 1. Screw
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjust ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
► Fig.9: 1. Angle head 2. Hole for adjust grip 3. Ring
4. Scale 5. Adjust grip 6. Hole for adjust grip
7. Yellow line 8. Compression spring
5. Use an optional adjust grip to adjust the fastening
torque. Insert the pin of the adjust grip into the hole
in the front of the tool. And then, turn the adjust grip
clockwise to set a greater fastening torque, and
counterclockwise to set a smaller fastening torque.
►
Fig.10
6. Align the yellow line with your desired number on
the fastening torque scale.
7. Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
8. Rotate the ring in front of the tool and then tighten
the screw to secure the ring.
NOTE:
• Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
► Fig.11: 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.