Makita DFL201F, Инструкция по эксплуатации, Страница: 8 / 52

8 ENGLISH
Adjusting the fastening torque
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures ring.
(Loosen the two screws that secure ring only for
DFL201F)
► Fig.7: 1. Screws
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjust ring
rotates and the hole becomes visible as illustrated.
And then remove the battery cartridge.
► Fig.8: 1. Angle head 2. Adjust ring 3. Ring 4. Scale
5. Adjust grip 6. Hole for adjust grip 7. Yellow
line 8. Compression spring
5. Use an optional adjust grip to adjust the fastening
torque. Insert the pin of the adjust grip into the
hole in the front of the tool. And then, turn the
adjust grip clockwise to set a greater fastening
torque, and counterclockwise to set a smaller
fastening torque.
► Fig.9
6. Align the edge of the adjust ring with your desired
number on the fastening torque scale.
7. Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
8. Rotate the ring so that the hole for adjust grip is
covered, hold and then secure the ring with screw.
NOTE:
• Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
► Fig.10: 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
OPERATION
► Fig.11
Hold the tool firmly and place the socket over the bolt
or nut. Then switch the tool on. When the clutch cuts
in, the motor will stop automatically. Then release the
switch trigger.
NOTE:
• Hold the tool with its square drive pointed
straight at the bolt or nut, or the bolt or nut will
be damaged.
Limits of fastening capacity
Use the tool within the range of the revolution angle up
to 360°. If you use the tool beyond the upper limit of this
range, the clutch does not work. And the tool cannot
deliver enough fastening torque (LED indicator blinks in
purple slowly or lights up in purple).
NOTE:
• The revolution angle means the angle which
a screw/bolt revolves when the tool attains to
100% from 50% of desired torque.
• Use of a low temperature conditioned battery
cartridge may sometimes give warning for
battery cartridge capacity by warning lamp and
beeper which makes the tool stop immediately.
In this case, the fastening capacity may be
inferior to the specification on this manual even
if a charged battery cartridge is used.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.