![background image](http://html1.mh-extra.com/html/makita/dcg180z/dcg180z_instruction-manual_3936479008.webp)
8
A
B
C
013611
For big holder (800ml(48.8cu.in))
D
015612
D
015607
Insert the rod into the slit of the tool.
Attach the piston and tighten it with a screw.
To remove the rod and piston, follow the installation
procedure in reverse.
NOTICE:
•
The teeth on the rod must point down.
•
There are four types of pistons. Piston A and D for
cartridges. Piston B for film type packs. Piston C
for direct filling.
•
Choose appropriate piston in accordance with the
type of caulking material container. Improper
piston may cause leakage or tool breakage.
•
There are three types of rods. The rod for the
short holder (300ml(18.3cu.in)), rod for long holder
(600ml(36.6cu.in)), and rod for big holder
(800ml(48.8cu.in)).
Use appropriate rod in
accordance with holder type.
•
Always keep the rod and piston clean. Adhering
caulk may damage the tool.
Installing holder
013562
Hold the bottom of the holder and the holder joint, then
turn the holder clockwise. Tighten it firmly until it stops.
Make sure the holder is tightened firmly. Otherwise the
tool may be damaged.
To remove the holder, turn it counter clockwise.
NOTE:
•
You can rotate the holder in accordance with
required situations to facilitate the operation.
•
The short holder (300ml(18.3cu.in)) and big holder
(800ml(48.8cu.in)) are intended for the cartridges
only. Use only piston A with short holder
(300ml(18.3cu.in)). Use only piston D with big
holder (800ml(48.8cu.in)) Do not use them with
film type packs or direct filling. Also use
appropriate rod in accordance with the holder type.
Installing cartridge
NOTICE:
•
Make sure the piston A is attached to the rod. Do
not use other type of piston for cartridge.
Installing the cartridge into the short holder
(300ml(18.3cu.in))
1
013566
Pull the rod handle backwards slowly until it stops.
013567
1. Rod handle