5
ENGLISH
Explanation of general view
1
Tighten
2
Chuck key
3
Side grip
4
Spade grip
5
Wrench holder
6
Loosen
7
Hex wrench
8
U
mark
9
Motor housing
10
Lock button
11
Handle
12
Press
13
Switch trigger
14
Reversing switch lever
15
A side
16
Clockwise
17
B side
18
Counterclockwise
19
Speed change knob
20
Pointer
21
Lock button
22
Reaction
23
Forward
24
Drilling in forward bit turns
clockwise
25
Reverse
26
Reversing bit turns
counterclockwise
27
Limit mark
28
Screwdriver
29
Brush holder cap
SPECIFICATIONS
Model
DA4030
DA4031
Drilling capacities
Wood
Auger-bit .................................................................................38 mm
38 mm
Self-feed bit.............................................................................65 mm
High: 65 mm
Low: 118
mm
Hole saw ................................................................................. —
152 mm
Steel ..........................................................................................13 mm
13 mm
No load speed (min
-1
)...................................................................1,200
High: 1,200
Low: 300
Overall length ...............................................................................417 mm
462 mm
Overall length (with an extended spade grip) ...............................491 mm
536 mm
Net weight.....................................................................................4.8 kg
5.6 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
SPECIFIC SAFETY RULES
GEB001-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to drill safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious per-
sonal injury.
1.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
2.
Hold tool by insulated gripping surfaces when
performing an operation where the cutting tools
may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal
parts of the tool “live” and shock the opeator.
3.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
4.
Hold the tool firmly.
5.
Keep hands away from rotating parts.
6.
Do not leave the tool running. Operate the tool
only when hand-held.
7.
Do not touch the drill bit or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
8.
Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
OPERATING INSTRUCTIONS
Installing or removing drill bit (Fig. 1)
CAUTION:
Always be sure that the tool is switched off and
unplugged before installing or removing the bit.
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly. To remove the bit,
turn the chuck key counterclockwise in just one hole,
then loosen the chuck by hand. After using the chuck key,
be sure to return it to the original position.
