[3] DISASSEMBLY/ASSEMBLY
[3] -1. Bent pipe complete (cont.)
[3] -2. Head case complete
ASSEMBLING
(1) Assemble Head case complete to Bent shaft pipe complete as drawn in
Fig. 3
.
(2) Assemble Loop hand set, Protector section, and Cutter assembly to Bent pipe complete in the reverse order of
Disassembly. Refer to
Fig. 2
.
Fig. 3
1. Pull out Flexible shaft to 100mm long from Bent shaft end.
Insert the square tip of Flexible shaft into the square hole
of Cutter shaft while turning.
1A. When replacing Flexible shaft with the
new
one,
place Bearing washer to the position that is 43 mm far
from the tip of Flexible shaft after step 1 shown above.
2. Align the hole of Head case complete with
the hole of Bend pipe complete.
The holes of Head case
complete and Bend pipe
complete for M5x10
Hex socket head bolt.
(1) Remove Head case complete from Bent pipe complete as
Fig. 2
.
(2) Remodel Hex wrench 5 as drawn in
Fig. 4
to fit to the square hole of Cutter shaft.
DISASSEMBLING
1. File off the two edges in order to fit Hex wrench 5
to the square hole of Cutter shaft.
Fig. 4
Head case
complete
Square hole of Cutter shaft
Bearing washer
100 mm
Bent shaft end
Head case
complete
Bend pipe
complete
100 mm
43 mm
Flexible shaft
(new)
R
epair
P
4
/ 1
3
Square tip of
Flexible shaft
2. Hex wrench 5 can be fit to the square hole of Cutter shaft.
