5
Installing or removing abrasive paper
For conventional type of abrasive paper with
pre-punched holes (standard equipment):
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the holes in the paper with
those in the pad. Then return the clamp lever to the
original position to secure the paper. Repeat the same
process for the other end of the tool, maintaining the
proper paper tension.
1
2
3
001682
For conventional type of abrasive paper without
pre-punched holes (accessory):
Turn the clamp lever counterclockwise. Insert the paper
end into the clamper, aligning the paper edges even and
parallel with the sides of the base. Then return the clamp
lever to the original position to secure the paper. Repeat
the same process for the other end of the tool,
maintaining the proper paper tension.
Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with
the sides of the pad. Then press the punch plate to
make holes in the paper.
1
2
001683
For hook-and-loop type of abrasive paper with
pre-punched holes (accessory):
Remove all dirt or foreign matter from the pad. Attach the
paper to the pad, aligning the holes in the paper with
those in the pad.
1
2
001684
CAUTION:
•
Never use pressure-sensitive abrasive paper.
For BO4901 only
1
2
3
004436
NOTE:
•
To use the hook-and-loop type of abrasive paper,
first replace the pad. Remove the pad for the
conventional type of abrasive paper from the tool
with a screwdriver.
Install the pad for the hook-and-loop type of
abrasive paper (optional accessory) on the tool.
Tighten the screws firmly to secure the pad.
Installing paper dust bag (accessory)
For BO4900, BO4900V only
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing
cardboard of the paper dust bag into the groove of the
paper dust bag holder.
1
2
3
001685
Then press the upper part of the front fixing card-board
in arrow direction to hook it onto the claws.
1. Groove
2. Front fixing
cardboard
3. Paper dust bag
1. Pad
2. Screws
3. Screwdriver
1. Hook-and-loop
type of abrasive
paper with
pre-punched
holes
2. Pad for
hook-and-loop
type of abrasive
paper
1. Punch plate
2. Conventional
type of abrasive
paper without
pre-punched
holes
1. Clamp lever
2. Conventional
type of abrasive
paper with
pre-punched
holes
3. Pad for
conventional
type of
abrasive paper
