Controller
Switch section
P 1
3
/1
3
Wiring on Switch section
1
raised portion
Lead wire holder
3
2
6
4
5
Switch unit
LED circuit
Micro switch
from Controller (blue)
from Controller (white)
Fix Lead wires with these Lead wire holders.
W
iring diagram
(2) Wiring on the Outside of Housing
Fig. D-3
Wiring of Lead wires (yellow, purple) that connect Switch unit with Controller
(These Lead wires are covered by a protective tube and called as
"Wire yp"
in the drawn below.)
Wire yp
Switch unit
pin A of Housing L
Wire yp
pin B of
Housing L
flanged portion
of Clutch case
pin C of
Housing L
Note:
Wire yp must be tight between Switch unit
and Lead wire holder of Housing L.
Route Wire yp:
3 under pin A of Housing L,
1 through the groove on Clutch case,
2 inside pin B of Housing L,
6 between the raised portion and flanged portion of
Clutch case,
4 inside pin C of Housing L,
5 through Lead wire holder of Housing L.
Wire yp Switch unit
Wiring on the shelf portion of Housing
Wire yp
shelf portion
of Housing
Put the following Connectors and slack portion of
Lead wires on the shelf portion of Housing:
• Connectors and Lead wires (including "Wire yp")
that connect Controller with Switch unit
• Connectors and Lead wires that connect Controller
with LED circuit
Note:
Be sure to put Connectors and the slack portion
in place carefully so that they are not pinched
between Housing and Clutch case cover.
LED circuit
Reverse
switch side
Micro
switch side
Assemble the receptacle on each
Lead wire to the terminal of
Switch section as drawn below.
receptacle
from Endbell complete
(black)
[Reverse switch side]
[Micro switch side]
from Endbell complete
(red)
from Controller
(purple)
from Controller
(orange)
from Controller
(white)
