![background image](http://html1.mh-extra.com/html/makita/bbc231u/bbc231u_technical-information_3875278010.webp)
Route Stater lead wires between Controller
and emboss of Housing L
Connect Flag terminals with Terminal so that
Lead wires face outside of Terminal. Do not
route the Lead wires between Terminal and Rib B.
Terminal viewed from the upper side
Fit 3-pin connector into the room on
Housing L as illustrated below, and then
put 6-pin connector on 3-pin connector
as illustrated right.
Before setting Main switch in place,
fit Reverse switch with lead wires into
the room and the lead wire holders of
Main grip L so that the thin lead wires
(black) should be placed lower than
the other lead wires. Be careful to
the direction of Reverse switch.
Controller
Terminal of
Stator
Rib B of
Housing L
emboss of
Housing L
Fig. D-2
W
iring diagram (for BBC230U and AT-3623)
P 1
0/
1
2
Flag terminal
Lead wires
3-pin connector
6-pin connector
5-pin
connector
Room on Housing L
for 3-pin connector
Do not put Lead wires on 3-pin connector and 6-pin connector.
Power supply cord unit
Main grip L
Tube
Rib C
Fit Connector into the room
of Main grip L as illustrated.
Be careful to the direction of
the connector.
Power supply cord unit
Tube
Strain
relief
Rib A
Align one end of Power supply cord with Rib A, and
secure Power supply cord unit with Strain relief.
Do not pinch Tube between Strain relief and Housing L.
Align the other end of Power supply cord with Rib C,
and secure Power supply cord unit with Strain relief.
Do not pinch Tube between Strain relief and Main grip L.
Room on Housing L
for 5-pin connector
Terminal
Reverse switch
Reverse switch
Main switch
Flag receptacle
Flag receptacle
with sleeve
Lead wire holders
of Main grip L
thin lead
wires (black)
Room of Main
grip L for
Reverse switch