11
Lubrication
To insure maximum performance, install an air set (oiler, reg-
ulator, air filter) as close as possible to the tool. Adjust the
oiler so that one drop of oil will be provided for every 20 nails.
When an air set is not used, oil the tool with pneumatic tool
oil by placing 2 (two) or 3 (three) drops into the air fitting. This
should be done before and after use. For proper lubrication,
the tool must be fired a couple of times after pneumatic tool
oil is introduced.
Selecting nails
CAUTION:
•
Do not drive hardened steel nails or stainless steel nails
into concrete or steel plate. If you do so, the nailer may
be adversely affected.
Always check the size of the nail head with the gauge on the
nail guide before loading the nailer. Different size nails may
be mixed up in the nails you purchase locally.
Do not use nails with a head size larger than D1 or smaller
than D2. Nails with a head size larger than D1 cannot be
inserted into the nail guide. Nails with a head size smaller
than D2 may move into the contact arm and cannot be
driven.
Nail guide
D1
D2
Gauge
