8 ENGLISH
Recommended cord
connected power source
Model
Portable power pack
ADRM13
PDC01
GRM04
PDC01/PDC1200
●
The cord connected battery pack(s) listed above may
not be available depending on your region of residence.
●
Before using the cord connected battery pack, read
instruction and cautionary markings on them.
INSTALLATION AND POWER
SUPPLY
CAUTION:
●
Always switch off the radio before installing or removing
the battery cartridge.
●
Be careful not to drop or strike the radio. Broken shell
may slash your finger or stab your body. Damaged
radio may exhibit unpredictable behaviour resulting in
fire, explosion or risk of injury.
●
Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
IMPORTANT:
●
Reduced power, distortion, stuttering sound or the
flashing
icon and backlight shows that the battery
needs to be replaced.
●
The battery cartridge is not included as standard
accessories.
Installing or removing the sliding
battery cartridge (Fig. 2-3)
1. Red indicator
●
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
●
If you can see the red indicator as shown in the figure,
it is not locked completely. Install it fully until the red
indicator cannot be seen. If not, it may accidentally
fall out of the radio, causing injury to you or someone
around you.
●
Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
●
To remove the battery cartridge, slide it from the radio
while sliding the button on the front of the cartridge.
Indicating the remaining battery
capacity (Fig. 4-5)
1. Indicator lamps
2. Check button
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
●
XGT/LXT battery cartridge
Indicator lamps
Remaining capacity
Lighted
Off
Blinking
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the battery
The battery may have
malfunctioned
NOTE:
●
Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
●
The first (far left) indicator lamp will brink when the
battery protection system works.
Charging with USB power supply port
NOTE:
●
Connect only devices which are compatible with DC
5V, 2.4A power source to the USB power supply port.
Otherwise it may cause malfunction to the product.
●
Connect the USB cable (not included) with the USB
power supply port of the product. And then connect the
other end of the cable with the device.
●
To start charging, press the USB charging on/off button
to enable the charging function. The USB charging on/
off button will light up green.
●
When the battery power is low, the screen backlight will
flash until the charging function is turned off.
●
If the charging function is turned on without charging,
the USB charging on/off button will flash green, and the
charging function will be automatically turned off after
30 minutes.
●
To stop charging, press the USB charging on/off button
to disable the charging function.
●
The maximum volume of the output power speaker will
decrease when your USB is charging.
IMPORTANT:
●
Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
