Makita 9565PZ, Инструкция по эксплуатации

Страница: 7 / 12

7
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (handle)
008373
CAUTION:
•
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel, flap disc /
abrasive cut-off wheel, diamond wheel)
WARNING:
•
When using a depressed center wheel, flap disc,
flex wheel or wire wheel brush, the wheel guard
must be fitted on the tool so that the closed side of
the guard always points toward the operator.
•
When using an abrasive cut-off / diamond wheel,
be sure to use only the special wheel guard
designed for use with cut-off wheels. (In some
European countries, when using a diamond wheel,
the ordinary guard can be used. Follow the
regulations in your country.)
For tool with locking screw type wheel guard
1
2
3
008374
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation
procedure in reverse.
For tool with clamp lever type wheel guard
1
2
3
4
008375
1
008376
Pull the lever in the direction of the arrow after
loosening the screw. Mount the wheel guard with the
protrusion on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard
around 180°. Fasten it with the screw after pulling lever
in the direction of the arrow for the working purpose.
The setting angle of the wheel guard can be adjusted
with the lever.
To remove wheel guard, follow the installation
procedure in reverse.
Installing or removing depressed center
grinding wheel / flap disc
(Optional accessory)
WARNING:
•
When using a depressed center wheel or flap disc,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1
2
3
013613
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
1. Wheel guard
2. Bearing box
3. Screw
1. Wheel guard
2. Bearing box
3. Screw
4. Lever
1. Screw
1. Lock nut
2. Depressed
center grinding
wheel/Flap-disc
3. Inner flange