(1) Disassembling
(a) Remove the steel band(for holding the rubber sleeve)mounted on the base from between the base and the frame.
(b) Remove the push buttons(2 pieces at back/forth) protruded above the top of frame.
(c) Remove the bearing retainer at center on the base. To disconnect it, place the minus screw driver on the cracked
point on the bearing retainer and turn the bearing retainer in left.
(d) Remove the pan head screw M5x12 holding the balance weight on the bearing #6003ZZ. At this time insert the
minus screw driver into the rubber sleeve to protect the balance weight from turning for easy disconnection.
R
epair
(2) Cautions in assembling
(a) Slightly grease the Grease(Albania No.2)on the needle bearing housed in the frame.
(b) When assembling the base, assemble it so that the face at base side can be parallel to the face at the frame side.
(e) Next disconnect the base. If hard to disconnect it due to the base tightly connected, insert the screw driver
between the frame and the base and disconnect while slightly twisting the driver.
