R
epair
P 9 / 13
< 5 > Assembling change ring
When separating gear assembly from housing, change ring can easily slip off from gear assembly.
Re-assemble change ring to gear assembly as follows.
1. Align the widest bulge of spring holder to the bulge of gear assembly by turning spring holder.
2. Assemble change ring by aligning the bulge of change ring's edge to the portion of gear assembly
marked with circle by the bulge of gear assembly.
Change ring
Bulge of
change ring's edge
Bulge of
change ring's edge
Bulge of
gear assembly
Bulge of
gear assembly
The widest bulge of
spring holder
1
2
3
4
16
15
14
1
2
3
4
16
15
14
< 3 > Disassembling gear assembly and motor section See Fig. 3.
Lifting up mode change lever, separated change ring, gear assembly, yoke, armature and endbell from housing
as a set.
< 4 > Assembling leaf spring See Fig. 5.
Assemble leaf spring to housing L as illustrated in Fig. 4.
Mode change lever
Change ring
Yoke
Armature
Endbell
Gear assembly
Remove as a set without separating from each other.
< Note in disassembling >
Remove so careful that the following springs
do not spring out.
Lock lever
Compression spring 2
Compression spring 2: installed in mode change
lever.
Torsion spring 2: fixing mode change lever
on gear assembly
Mode change lever
Torsion spring 2
Gear assembly
Fig. 3
Fig. 4
Fig. 5
Leaf spring
Housing L
Housing L
