![background image](http://html.mh-extra.com/html/makita/4200nh/4200nh_instruction-manual_231894006.webp)
6
Do not use dull or damaged blade.
Unsharpened or improperly set blades pro-
duce narrow kerf causing excessive friction,
blade binding and KICKBACK. Keep blade
sharp and clean. Gum and wood pitch hard-
ened on blades slows saw and increases
potential for kickback. Keep blade clean by
first removing it from tool, then cleaning it
with gum and pitch remover, hot water or ker-
osene. Never use gasoline.
Blade depth and bevel adjusting locking
levers must be tight and secure before
making cut.
If blade adjustment shifts while
cutting, it may cause binding and KICKBACK.
Use extra caution when making a “Pocket
Cut” into existing walls or other blind
areas.
The protruding blade may cut objects
that can cause KICKBACK. For pocket cuts,
retract lower guard using retracting Lever.
ALWAYS hold the tool firmly with both
hands. NEVER place your hand or fingers
behind the saw.
If kickback occurs, the saw
could easily jump backwards over your hand,
leading to serious personal injury.
Never force the saw. Forcing the saw can
cause uneven cuts, loss of accuracy, and
possible kickback.
Push the saw forward at
a speed so that the blade cuts without slow-
ing.
12. Use extra caution when cutting damp
wood, pressure treated lumber, or wood
containing knots.
Adjust speed of cut to
maintain smooth advancement of tool without
decrease in blade speed.
13. Adjustments.
Before
cutting
be
sure
depth and bevel adjustments are tight.
14. Avoid Cutting Nails. Inspect for and
remove all nails from lumber before cut-
ting.
15. When operating the saw, keep the cord
away from the cutting area and position it
so that it will not be caught on the work-
piece during the cutting operation. The
tool is provided with a front grip and rear
handle for two hand operation. Operate
with proper hand support, proper work-
piece support, and supply cord routing
away from the work area.
WARNING: It is important to support the
workpiece properly and to hold the saw
firmly to prevent loss of control which
could cause personal injury. Fig. 4 illus-
trates typical hand support of the saw.
Fig. 1
To avoid kickback, do support board or
panel near the cut.
Fig. 2
Do not support board or panel away
from the cut.
Fig. 3