Makita 4107RH, Инструкция по эксплуатации

Страница: 4 / 12

4
ADDITIONAL SAFETY RULES
ENB052-2
1.
This tool is equipped with a portable residual
current device. Do not connect the tool to a
power supply without using the PRCD (Portable
Residual Current Device). In case of damage of
the cord, it has to be replaced by the manufac-
turer’s service organization.
2.
For additional protection against electric shock,
be sure to WEAR RUBBER GLOVES AND RUB-
BER BOOTS during operation.
3.
Check the wheel carefully for cracks or damage
before operation. Replace cracked or damaged
wheel immediately.
4.
Use only flanges specified for this tool.
5.
Be careful not to damage the spindle, flanges
(especially the installing surface) or bolt. Dam-
age to these parts could result in wheel break-
age.
6.
When using the water feed, be careful not to let
water get into the motor. If water runs into the
motor, an electric shock hazard may result.
7.
Hold the tool firmly.
8.
Keep hands away from rotating parts.
9.
Make sure the wheel is not contacting the work-
piece before the switch is turned on.
10.
Wait until the wheel attains full speed before
cutting.
11.
Stop operation immediately if you notice any-
thing abnormal.
12.
Never attempt to cut with the tool held upside
down in a vise. This can lead to serious acci-
dents, because it is extremely dangerous.(Fig.
1)
13.
Before setting the tool down after completing a
cut, be sure that the wheel has come to a com-
plete stop.
14.
Do not stop the wheel by lateral pressure on the
disc.
SAVE THESE INSTRUCTIONS