Makino V55, Руководство по обслуживанию

Страница: 232 / 568

6 - 30
Adjusting LS01
1. Display the Custom -
DIAGNOSE
screen (
Figure 6-
19
).
A. Press the [CUSTOM]
function key. (If required,
press [PO] to display the
[MS] softkey.)
B. Press [MS], to display
[DIAGNOSE].
C. Press the [DIAGNOSE].
2. Use [NO. SEARCH], to
display Diagnostic No. 00.
- The current status of
LS00 (X00.0) and LS01 (X00.1) is displayed at the bottom of the
screen.
3. Remove the upper spindle cover,
section 6.10
(pg 6-80)
.
4. Use the [TOOL UNCLAMP] button and manually remove tooling from
the spindle.
5. Loosen the (M6) lock nut [1].
6. Turn adjusting screw [2] CCW, until the
input for LS01 goes low (LS01 = 0).
7. Turn adjusting screw [2] CW, until the
input for LS01 just goes high (LS01 = 1),
then turn 1.5mm (0.060") further, and
tighten lock nut [1].
8. Use [TOOL UNCLAMP] to manually load
a tool into the spindle.
9. Check the input status of LS00 and LS01
and readjust, if necessary.
- With spindle unclamped, inputs should
be: LS00 = 0 and LS01 = 1
- With spindle clamped, inputs should
be: LS00 = 1 and LS01 = 0
10. Replace the upper spindle cover.
F
IGURE
6-19
CUSTOM DIAGNOSE SCREEN
F
IGURE
6-20 LS01
ADJUST
-
MENT