Makino EDGE-2, Руководство по предварительной установке, Страница: 94 / 120

5 - 4
('*(
3UH,QVWDOODWLRQ*XLGH
5.3.1 Lifting and Moving the Machine
1. Verify the machine moving
members - X and Y axes and
ATC are securely retained by
the yellow or orange painted
shipping locks (
Figure 5-1
).
A. Y axis shipping lock is
located on the left behind
access plate [2].
B. X axis shipping lock is
located on the back
behind access plate [1].
C. ATC shipping lock is
viewed from the front.
2. Attach the lifting fixture to an
overhead crane (
Figure 5-2
)
and center it over the
machine
3. Place the cable loops over
the lifting bars, as shown in
Figure 5-2
.
4. Slowly raise the crane hook
to remove slack in the
cables, checking for interference with machine components. Use
heavy pads or wood blocks at interference points. .
5. Lift the machine and move to installation site.
6. Set 300mm blocking under the machine, near each leveling point.
Lifting and Moving Hazard
When lifting or moving the machine:
1. Make sure machine is balanced. Keep the machine level and lift or move gently.
2. Lift no higher than needed. Keep all body parts from under the machine.
3. Prevent impact with any nearby objects.
4. Do Not remove axis locks or move any axis. Axis locks will be removed by the FSE.
F
IGURE
5-1
SHIPPING LOCKS
Legend
[1] X Axis Shipping Lock
[2] Y Axis Shipping Lock
[3] ATC Shipping Lock
Rigging Detail
Makino machines are designed to be lifted by overhead crane. The required rigging is
shipped with the machine. If using a fork lift BE SURE to approach from the machine
side (Not the NC side).