Floor Stripper
– User Manual (Rev0919)
Page 12 of 17
VINYL STRIPPER DOES NOT START
During operation, if the unit suddenly shuts down and does not start when it is ON, the
motor overloaded and the circuit breaker was tripped. To reset the circuit breaker, do the
following.
TRANSPORTING AND STORING
CAUTION
Follow all the steps below to ensure safety.
It is important to ensure the wheels are on the ground at all time during use, storage and
transportation via the wheels.
WARNING
Never transport the Vinyl Stripper with the blade installed as it can
damage the product and the blade
1. Remove blade before transporting and storing.
2. Remove/ lower the handle for storage and transportation.
3. Lay protective sheet on surface of the Vinyl Stripper during storage.
4. If lifting and lowering is required, take off the removable weight from the Vinyl Stripper.
CAUTION
Always lift the machine with two people or alternatively use a crane on
the lifting eye supplied.
Identify the Push Circuit Breaker
location, underneath the unit.
Push the red button in the hole.
