Recognizing Existing Controls
The MAKESafe Power Tool Control is designed for use on tools with a simple on/off switch and no
pre-existing electronic controls. If your power tool has any other controls, electronic indicators,
digital displays, starters, dials or variable controls, magnetic switches, or variable frequency drives
- do not install the MAKESafe Power Tool Control. If you have questions about compatibility,
contact MAKESafe Tools for assistance.
Installation
You can find a video companion for these installation and calibration instructions on our website at
1. Unbox the product and inspect the device and shipping containers for any damage that may
have been incurred during shipping.
2. Plug your control panel into the product by inserting the silver connector on the control panel
cable into the mating connector on the product. The connector will only fit in one orientation
so rotate it gently until it snaps into place. Once mated, manually screw the control panel
connector clockwise to lock it in place. Hand-tighten the connector until snug (do not use
tools to tighten).
3. Plug your
power tool
into the
power tool receptacle
on the
product
. It is important to plug
your tool into the product before plugging the product into the wall.
4. Once your
power tool
is plugged into the product, plug the product into a power outlet.
5. Mount the
control panel
to your
power tool
in a convenient to access location.
6. Turn the on/off switch on your
power tool
to the ‘on’ position. Note that the
power tool
switch must now remain in the ‘on’ position at all times. To prevent tampering or otherwise
being turned ‘off’, cover the power tool switch. If this device is being used in a workplace,
refer to the
Occupational Safety Standards
section for further information.
7. Now that you have completed the installation, proceed to the
Calibration
section to calibrate
your device.
MAKESafe Tools, Inc. | Copyright 2021 | Last Updated 1/4/22
Page 6
