Filament Drive, Fan and Hotend Assembly
(1)
Filament Drive/Fan assembly
(1)
Hot End assembly
(1)
M3x12 socket head screw
(2)
M3x25 socket head screws, washers, reused from
disassembly process
(1)
M3x45 flathead screw
•
Thread the (1) M3x12 screw into the side hole of the
extruder plate, but do not tighten.
•
From under the mounting plate, individually feed the
white and black wires through the hole just in front of
the motor mount.
•
Insert the hotend into the slotted hole, with the top
surface protruding slightly above or flush with the top
surface of the mounting plate. Rotate so that the black
and white wires flow freely through their hole.
•
Tighten the (1) M3x12 screw securing the hotend into
place.
•
Connect the white wire to the H0 connector in the ECB
and the black wire to the EXT connector.
•
Rotate the fan on the filament drive so that you can
clearly see all parts of the filament drive.
•
Place the Filament Drive onto the motor with the flat
surface touching the motor face. The conical protrusion
from the filament drive should face downwards.
•
Slide (2) M3x25 screws with washers into the top right
and bottom left holes on the front of the Filament Drive.
Rotate the Filament Drive to align the hole at the base
of the protrusion with the hole on top of the hotend.
Tighten.
•
Rotate the fan on the filament drive so that empty
hole is in the lower right. Insert the M3x45 screw and
tighten.
•
Connect the upper fan to the F1 connector and the lower
fan to the F0 connector.
