Installing the new belt clamp and mounting plate
•
Install the new belt clamp on the front belt span with the fins
facing the back of the printer
• Place the new extruder mounting plate on top of the belt
clamp and the X-axis carriage
• Insert and tighten the (x4)
M3x18
screws through the back
four mounting plate screw holes to secure the belt clamp
• Insert the (x2)
M3x10
screws through the two rearmost holes
to tighten the mounting plate to the X rail carriage
• Place the new motor mount on top of the mounting plate with
the printed wiring box facing the rear
• Insert (x2)
M3x14
screws and tighten while pulling the motor
mount towards the front
• Noting the location of the connector, remove the three M3
bolts from the extruder motor using a 2.5mm wrench
• Place the motor through the motor mount with the connector
facing right
• Insert and tighten the (x3)
M3x28
screws to secure the motor
Parts needed for this step:
• x1 - Extruder mounting plate
• x1 - Belt clamp
• x1 - Metal motor mount with printed wiring box
• x2 - M3x14 socket head screws
• x3 - M3x28 socket head screws
•
x2 - M3x10 flathead screws
•
x4 - M3x18 flathead screws
Step 2: Install the extruder mounting plate
4
