7
MakerBot Replicator
MakerBot
7
MakerBot Replicator Z18
MakerBot
Remove four (4) button heads of
the
Drawer Bay Assembly Top
Cover
by using the 2.5mm hex
Unplug the
Z-Motor
from the
Motor Wire Harness
. Unclip the
Z-Motor Wire Harness
from the
plastic wire clip
Remove two (4) button head
hex screws from the two (2)
UI
Adapter Mount
located at the
front of the
Drawer Bay Assembly
by using 2.5mm hex screwdriver.
Unplug the
Heating Coil
Thermistor
attached to the
Heating Coil Assembly
.
Lift up the
Inner
and
Bottom
Panels
over the threaded rods.
Step 9 - Remove Z-Stage
Continued
Step 9 - Removing the Drawer
Bay Cover
Unplug the
Heater Fan
from the
Gowanus PCB
located in the
rear
Electronics Bay
, lift off the
Top Cover
of the
Drawer Bay
Assembly
.
•
•
•
•
•
