18. Return the electronics cover to the bottom of the MakerBot Replicator 2X.
Use the four small bolts and the 2.5 mm hex wrench to secure the cover to the bottom
of your bot and flip the bot upright again.
19. Enclose the extruder cable wires in the wire wrapping.
Wrap the wire wrapping around the length of the bundle of extruder wires.
20. Attach the extruder end of the extruder cable to the plastic guide at the back
of the extruder.
Pull the zip tie very tight and clip off the excess.
21. Reattach the extruder cable to the back of the MakerBot Replicator 2X.
Move your extruders all the way to the front left corner of the MakerBot Replicator 2X.
Zip tie the cable to the clip at the top of the back of your bot, leaving a small amount of
slack on the cable. Push the cable into the other guides on the back of the bot.
22. The replacement is now complete, but your two extruder nozzles are now at
different heights. Before printing again, use the
instructions on our website to realign them.
