Make Audio Annex Basic Kit Assembly Instructions
Revision 1.0
pg. 8
3.5 Transducer Installation
With the speaker cabinet lying back face down, push the female terminals on the blue+black
wires on to the tweeter make terminals. To prevent excessive bending, support the back side of
the male terminal when pushing on the wire terminals.
Repeat with the red+black wires and the woofer.
Secure the transducers to the cabinet with the black #6 x 5/8” screws. Do not over-tighten the
screws. If using a cordless, ensure the torque setting is low and the transducer is protected from
a slipping bit with cardboard or your hand.
3.6 (Optional) Rubber Bumper Installation
Remove the rubber bumpers from their backing and push them on to each corner of the bottom
panel. The bumpers can also be installed on your speaker stands.
Congratulations! You have
completed assembly of the Annex Bookshelf / Monitor Speaker.
If you have questions about this document or the assembly of your speaker, please contact us at
