Major tech MT22, Инструкция по эксплуатации

Страница: 4 / 16

4
1. SAFETY INFORMATION
The following safety information must be observed to insure maximum
personal safety during the operation at this meter:
Ÿ Do not use the meter if the meter or test leads look damaged, or if you
suspect that the meter is not operating properly.
Ÿ
Never earth yourself when taking electrical measurements. Do not
touch exposed metal pipes, outlets, fixtures, etc., which might be at
earth potential. Keep your body isolated from earth by using dry
clothing, rubber shoes, rubber mats, or any approved insulating
material.
Ÿ Turn off power to the circuit under test before cutting, unsoldering, or
breaking the circuit. Small amounts of current can be dangerous.
Ÿ Use caution when working above 60V DC or 30V AC RMS. Such
voltages pose a shock hazard.
Ÿ When using the probes, keep your fingers behind the finger guards on
the probes.
Ÿ Measuring voltage which exceeds the limits of the multimeter may
damage the meter and expose the operator to a shock hazard. Always
recognise the meter voltage limits as stated on the front of the meter.
Ÿ Never apply voltage or current to the meter that exceeds the specified
maximum:
This symbol adjacent to another symbol, terminal or
operating device indicates that the operator must refer to an
explanation in the Operating Instructions to avoid personal
injury or damage to the meter.
This WARNING symbol indicates a potentially hazardous
situation, which if not avoided, could result in death or
serious injury.
This CAUTION symbol indicates a potentially hazardous
situation, which if not avoided, may result damage to the
product.
This symbol advises the user that the terminal(s) so marked
must not be connected to a circuit point at which the voltage
with respect to earth ground exceeds (in this case) 500 VAC
or VDC.
This symbol adjacent to one or more terminals identifies
them as being associated with ranges that may, in normal
use, be subjected to particularly hazardous voltages. For
maximum safety, the meter and its test leads should not be
handled when these terminals are energized.
MAX
500V
2. SAFETY SYMBOLS