Majestic WT 247, Инструкция по эксплуатации

Страница: 16 / 24

P. 6
3. Slide open the battery door of your second transmitter, slide the switch to the middle position marked with 2 ,
then insert two AAA batteries into the battery compartment by observing the c/- polarity. Replace the
battery cover.
4. The outdoor temperature and humidity of your second transmitter will appear on the LCD together with
icon within few seconds. If the data still does not appear, press RESET at the front of your second transmitter
once.
5. To synchronize your weather station with a third outdoor sensor, repeat the same step by choosing
on
your weather station and select 3 on your third transmitter.
AUTO SCROLLING THE OUTDOOR TEMPERATURE AND HUMIDITY OF DIFFERENT
TRANSMITTER
Press  / CHANNEL one at a time until the icon flashes. Then the outdoor temperature and humidity of
different outdoor transmitter will be displayed for few seconds alternately with , , flashing.
To stop the auto scrolling, press  / CHANNEL once to go back to constant display of the temperature and
humidity of the transmitter, the icon remains static on the display.
LOW BATTERY INDICATION OF YOUR OUTDOOR TRANSMITTER
The icon will appear to indicate the battery level of your outdoor transmitter is getting low. You may
need to replace the batteries of your outdoor transmitter with new ones.
Extreme cold weather (e.g. below -10
°
C) will also cause low battery voltage.
TROUBLESHOOTING
In case your weather station clock shows irrelevant information or digits, it maybe affected by
electrostatic discharge or interferences from other devices. Use a sharp object to press
RESET . Your
unit will be reset to default settings and you need to set the time, calendar and alarm time again.
Problem Solution
LCD is blank 1. Press RESET on the main unit.
2. Replace fresh batteries in your weather station.
No Outdoor Temperature and
Humidity is displayed 1. Press and hold  / CHANNEL on the weather station.
2. Press RESET on the outdoor transmitter.
3. Make sure the correct channel is selected on your
weather station (default setting is – Channel 1)
4. Observe if the Low Battery icon appears on the left of the
outdoor temperature. If yes, replace batteries in outdoor
sensor with fresh alkaline batteries.
5. No other interfering sources are being used (such as
computer monitors, TV sets, headphones, or speakers) in
the path of signal from the outdoor sensor. The signal
travels in a straight line, an electrical source near that
“line” may cause interference.
Temperature, humidity, or air
pressure is incorrect
1. Press RESET on the main unit.
2. Make sure your main unit and the outdoor transmitter is
away from sources of heat / cold / direct sunshine.