SLEEP TIMER OPERATION
The sleep timer allows you to play music for a preset amount of
time ranging from 90 minutes to 10 minutes. It is commonly used
by people who prefer to go to sleep to music.
1. In radio mode, Press the SNOOZE/SLEEP/DIMMER button.
The display will show 90 minutes, your clock radio will turn off
in 90 minutes.
2. To change the number of minutes for the SLEEP timer, press
the SNOOZE/SLEEP/DIMMER button until you see the
desired number of minutes. The SLEEP timer decreases in
increments of 10.
3. To cancel the SLEEP timer, press the SNOOZE/SLEEP/
DIMMER button then press again until you see OFF in the
display or press the POWER ON – OFF / ALARM OFF button.
DIMMER CONTROL
In radio off mode, Tap the DIMMER button to set the brightness
of the LED display to high or low according to your ambient light
conditions.
Remark:
1. Clock display with dimmer low” is the default setting.
2. It will consume more power if you set the clock display with
dimmer high.
RESETTING THE UNIT
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller
to shut down automatically. If this occurs, disconnect the AC
POWER CORD from the wall and remove the backup battery from
the compartment. Wait at least 3 minutes, and reinsert the battery
for the back-up, and reattach the AC Cord to the wall. The unit
is now reset, so you will need to setup the unit time and alarms
again.
SPECIFICATIONS
Frequency :
FM 87.5 – 108 MHz
Battery backup : 1 x 3V CR2032 flat lithium battery (not included)
Power source : AC 230V ~ 50Hz, 5W
