3
Majestic • GLQUARTZ36PLA Installation Instructions • 2643-945 • 4/22
9. Locate the two upper glass brackets that are shipped
flat. Bend the “Right” bracket as shown in Figure 8.
Bend the “Left” bracket shown in Figure 9. The rear
hand bend feature, circled in Figure 9, is left flat until
step 12.
10. Install right upper glass bracket by pushing the bracket
“up” to the firebox top and “out” to the front face of the
firebox. The front edge of the bracket should be tight
to the firebox face and the top edge of the bracket
should be tight to the firebox top. Install the bracket
by inserting the two self-tapping screws through the
bracket into the firebox. See Figure 8. Repeat step
10 for left upper glass bracket installation.
Figure 7 Install Sleeves
Figure 8 Bend Upper Glass Brackets
(Upper Right Bracket Shown)
11. Install the rear glass panel by placing the lower edge
into the rear lower glass bracket. Ensure the smooth
side is facing toward the front of the fireplace. Tip
glass back until the glass touches the screw head
previously installed in Step 8. Keep one hand on the
rear glass panel and proceed to Step 12.
12. With one hand on the rear glass panel, bend “up”
one hand bend tab on the upper glass bracket to
approximately 90 degrees. See Figure 9. Once
the hand bend tab is properly bent, the glass panel
will not tip forward. Bend “up” the hand bend tab on
the opposing bracket. The rear glass panel is now
installed. This panel will be held in place by the side
panels once they are installed.
13. Install left glass panel by inserting the glass panel
from the front. Slide panel back until it contacts the
rear glass panel. Ensure that the tab shown below is
bent “down” on each upper glass bracket to secure
left/right glass panels. Repeat Step 13 for right glass
panel installation.
Figure 9 Upper Glass Brackets Installed (Left Upper Bracket Shown)
Figure 10 Install Left Glass Panel
BEND THESE
FEATURES
SCREW HOLES
HAND BEND TAB
SUPPORT
TAB
