15
Majestic • ECHEL36IN, ECHEL36STIN, ECHEL48IN, ECHEL48STIN, ECHEL60IN, ECHEL72IN Owner’s Manual • 2406-971 Rev. D • 10/17
B. Maintenance Tasks: Homeowner
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any of
the listed tasks, please call your dealer for a service ap
-
pointment.
More frequent cleaning may be required due to lint from
carpeting or other factors. Control compartment, burner
and circulating air passageway of the fireplace must be
kept clean.
CAUTION! Risk of Burns!
The fireplace should be
turned off and cooled before servicing.
Any safety screen or guard removed for servicing must be
replaced prior to operating the fireplace.
Installation and repair should be done by a qualified service
technician only. The fireplace should be inspected before
use and at least annually by a professional service person.
4
Maintenance and Service
Task
Frequency
To be completed by
Glass Cleaning
Seasonally
Homeowner
Doors/Fronts/
Surrounds
Annually
Remote Control
Seasonally
Venting
Seasonally
Gasket Seal
and Glass
Inspection
Annually
Qualified Service
Technician
Log Inspection
Annually
Firebox
Inspection
Annually
Control
Compartment &
Firebox Top
Annually
Burner Ignition
& Operation
Annually
A. Maintenance: Frequency and Tasks
The matrix below is an overview of maintenance tasks to
be performed on the appliance. Sections B and C give
details and instructions needed to assist the appropriate
person in performing the tasks.
When properly maintained, your fireplace will give you
many years of trouble-free service.
Contact your dealer
to answer questions regarding proper operation, trouble-
shooting and service for your appliance. Visit www.ma
-
jesticproducts.com to locate a dealer. We recommend
annual service by a qualified service technician.
Glass Cleaning
Frequency:
Seasonally
By:
Homeowner
Tools Needed
: Protective gloves, glass cleaner, drop
cloth and a stable work surface.
WARNING!
Handle fixed glass assembly with care.
Glass is breakable. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
•
DO NOT
clean glass while it is hot
•
Replace as a complete assembly.
•
Prepare a work area large enough to accommodate fixed
glass assembly and door frame by placing a drop cloth
on a flat, stable surface.
Note
: Fixed glass assembly and gasketing may have res
-
idue that can stain carpeting or floor surfaces.
Removing Fixed Glass Assembly
1. Remove the decorative front from fireplace and set
aside on work surface.
2. Remove bottom glass shield.
3. Locate the glass spring latches that are on the upper
edge of the glass frame of the appliance. See Figure
4.1.
4. Use both index fingers to release spring latches. See
Figure 4.1.
5. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and lift up and out. The glass
should lift easily out of the bottom retaining lip.
Cleaning Fixed Glass Assembly
• Clean glass with a non-abrasive commercially available
cleaner
.
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer)
Replacing Fixed Glass Assembly
1. Locate retaining lip on lower front face of firebox.
2. Place glass assembly into retaining lip end. Tilt top of
glass assembly toward fireplace.
3. Carefully set fixed glass assembly in place on fire
-
place. Hold glass in place with one hand and secure
glass latches with the other hand.
Assure proper left
and right placement of glass and engage all four
spring latches.
4. Reinstall bottom glass shield.
5. Reinstall decorative front.
